FX3U ethernet connection status

dmta

Member
D
Join Date
Sep 2015
Location
Tyhk
Posts
7
Dear all,

I am using an FX3u PLC along with an FX3u-ENET-ADP card and the card is connected to a PC which runs kepServer 5.19

Is there a way for me to know (from the PLC end) whether the communication between PC and PLC has been established (some sort of a special relay would be really good) ?

Best ragerds
 

Similar Topics

N
FX3U Ethernet module 1151hmi
FX3U - Ethernet module - Beiger 1151hmi I have these setup on a press which all worked fine. But since swapping the FXU3-80 for a smaller FXU3-48...
Replies
9
Views
2,868
Dariusch
D
A
Communication between FX3U and FX3g PLC using Ethernet Module
Hi, I am working on Mitsubishi PLC project.I am using two PLC below. PLC 1 - FX3U (Master) IP : 192.168.0.10 PLC 2 - FX3g (Slave) IP ...
Replies
0
Views
4,657
ankit_patel291
A
N
Melsec FX3U Ethernet connect to E1071 HMI
Wonder if some1 can help me. Im busy with a project and using a FX3U plc with a FX3U-ENET-L ethernet controller connected to a Beijer E1071 HMI...
Replies
4
Views
4,072
plcduck
P
K
FX3U ethernet com. problems
Hey, I've som problems with the PLC to communicate through a router or switch using an FX3UENET module. When I connect directly to my PC, it work...
Replies
0
Views
1,705
[email protected]
K
C
Mitsubishi FX3U Ethernet and Internet
My setup is as follows: FX3U PLC with ENET module. IP address 192.168.100.201. Have a Melsoft connection set for connection 4. Router: LAN...
Replies
1
Views
6,351
shyamsandeep
S
Back
Top Bottom