Problems with RSView 32, doesn't open

Hello plctalk.net community,

I am trying to create an RSView32 file for a PLC program I have created.
I am simulating the PLC program using RSLogix Emulate 5000.

Everytime I try to close the RSView32 it doesn't respond properly and I have to End the application via the Task Manager (End Task).

When I try to open it again, the introduction screen appears (Fig1.jpeg shown below), and then that's it. Nothing happens.

Any help regarding this issue is very well appreciated


OS
Windows 7 Professional
Service Pack 1
32 bits

RSView32 Works 100K Version 7.50.00

RSLogix Emulate 5000 Version 19.01.00

PN: I am using the computer as an administrator.


Regards,

Forat

http://www.plctalk.net/qanda/showthread.php?t=49916

Check out the above post.

Regards,

Sorry for the late reply, thanks a lot Garry the link did help.

Forat.