Hello everyone! I have a machine with about 15 servos. On the PanelView on that machine I want to make a display that can show a trend of the Torque Feedback. I just want to display one trend at a time and use a button for each servo to display that trend. So I am visualizing a large trend chart at the top and a list of all the sevos below that can be selected. Does anyone have any suggestions on a good way to do this? Is there a better way than having a button for each servo?
Servo Trend Display on PanelView
- Thread starter jrsnydley
- Start date
widelto
Member
You can use a counter (0 to 14)that changes every 30 seconds, every time the counter changes you can view a different servo feedback on your PV.
Similar Topics
Good morning,
We've had an issue with a couple of servo valves and was wondering if anyone had seen anything similar.
After a drop in pressure...
Hello all,
I'm currently working on a servo motor linear positioning system (ball screw). I'm all set up regarding communication between my HMI...
Hi all,
I am having a machine with old 802d sl siemens controller. I am trying to tune servo by Siemens starter software. Anyone experienced...
Hi,
I'm thinking about using commands for Melservo J5 controller via HMI without PLC.
Have you guys done this kind of control configuration for...
Is it possible for me to tuning 2 servo at the same time, because this servo is connected by mechanical so I'm afraid that I need to tuning them...