how to connect Citect and M340 PLC

Hello Expert,
I am working on a project that will interface Modicon M340 Plc and Citect version 7.4.
I have tested my PLC program and it is working fine.
Also I have setup my citect server and the configuration is fine.
My challenge is the I/O addressing.
Kindly assist me on how I will enter my input and output address which I have on my M340 in the citect server variable tage.
for example,
How to label the input (%10.1.32) in my citect variable tag.
Also how to label the output (%Q0.2.22) in my citect variable tag

http://www.plctalk.net/qanda/showthread.php?t=54556

This thread should help you out.

Regards,

Thanks expert for your quick support as this show why I believe in this site.
Back to the topic,
I have tried to move my topological i/o to memory bit like
%M100:= %I0.1.18;
but each time I analyze my program it is complaining of memory overlapping.
Can you assist with this