Kataeb
Member
when we go online in the simatic hardware configuration, we have an et200 station IM153-2 redundant, which has a small red line at its top left corner. module information is ok, diagnostic is without errors. all leds are green.
what does this red line mean?
note that this et200 window in hw config, does not show any module, probably because we have some missing software packages, like the used for safety modules (one is actually installed).
what does this red line mean?
note that this et200 window in hw config, does not show any module, probably because we have some missing software packages, like the used for safety modules (one is actually installed).