S7 Microwin V4 - Latch and unlatch - Set 1 an reset 0

Hi everyone I'm trying to reset the timers of my sequence so I created two
latches called "inicio" and "ON_3PF", I am no expert programming PLC so I
have this confusion with the use of latches.

The issue I have is that these tags(inicio and ON_3PF) won't reset at the end
of the sequence in the network 7, maybe because I use normally open
contact with the timer "T39", when the timer reaches the limit time remains
ON, I don't know what type of contact I should use though.

I add links to the programm running and stopped.

I hope anyone can give me a tip on this issue so I can reset the latch.

Best regards.



Link1 (offline program part 1)
http://s20.postimg.org/jcnrkguxp/program_1.png

Link2 (offline program part 2)
http://s20.postimg.org/p2404s13x/program_1_1.png

Link 3 (online program network 1)
http://s20.postimg.org/mz387yx0d/N1_ACT.jpg

link 4 (online program network 7)
http://s20.postimg.org/5zu9splst/N6_Y_N7_ACT.jpg

Look on the network 7. In both resets put 1 instead of 0. It's the bit count to be set/reset.

thank you

adfox said:

Look on the network 7. In both resets put 1 instead of 0. It's the bit count to be set/reset.

Click to expand...

great, I'll try that.
at this moment I don't have a PLC I'm gonna need to try it on a PLC simulation, but need to get it and install first, lol.


Have a great day and thanks for taking the time to check my program.

best regards:site: