ControlLogix and Ramsey 9101 Integrator

ShadowFire

Member
S
Join Date
Mar 2016
Location
Secunda
Posts
2
Hi,

I would like to connect a Ramsey Micro-Tech 9101 integrator via Ethernet to a Controllogix Controller. I have tried using the Generic Ethernet Module but am not sure how to configure it. Could someone please assist?
 

Similar Topics

T
ControlLogix Redundancy Module Single Mode Fiber
Why does the controllogix redundancy modules use a single mode fiber vs multimode fiber?
Replies
1
Views
78
Ken Moore
Ken Moore
B
ControlLogix IB16IF and OB16IEF
Hello, I have two 16 point input cards and 1 16 point output card showing module faulted on my IO tree in Logix Designer. The fault code is...
Replies
7
Views
213
Contr_Conn
Contr_Conn
S
ControlLogix Redundancy with EN2TR
Hello, My associate and I are trying to sync up two ControlLogix racks (7-slot chassis) with identical modules. We are able to see the secondary...
Replies
4
Views
190
Contr_Conn
Contr_Conn
J
ControlLogix L71 Reading from 5/80E ver D.1
Trying to setup a message read via Ethernet. I have the path setup as 1, 1, 2, 192.168.66.10 I get an error code 1, ext err 315. I am beating...
Replies
9
Views
229
just_lionel
J
A
SLC messaging with a ControlLogix redundant system
I have a redundant ControlLogix being set up. This program reads a value from a remote site which happens to be SLC PLC. Rockwell mentions SLC...
Replies
2
Views
94
robertmee
R
Back
Top Bottom