GE Fanuc

I Have a machine that the control part is a
Plc GE Fanuc Series one junior(Ic609sjr120c)
,and now i have problem with this plc,
because I don't have any manual & software programming
and cable to install this plc.So kindly ask you to help
me to install this plc .
I'm waiting for you reply Asap.

Wow, the GE Series One Jr. has been obsolete for many years. You might get some help from GE, but I don't think they support it anymore.

I'm not sure if you could even find a manual or a handheld programmer for it. your local GE distributor might have a copy of the manuals and possibly a copy of Logicmaster software, but then again perhaps not.

I can say that Automationdirect does support the GE Series One, but not the Junior.

Sorry.

The manual for the Series One Junior is publication number GEK-90503. It is not available online, but is published in pdf format. It is on the "Legacy Products" CD which you should be able to obtain from your local supplier of GE Fanuc products. If that fails, send me a PM and I can email it to you, Be aware that it is a large file (25 meg), so you need to have a broadband internet connection.

The handheld programmer for the Series One Junior is the same unit as for the Series One. Thus, the handheld for the Automation Direct DL305 should also work with the Junior.

The programming software for the Series One Junior requires that a Data Communications Unit be installed. Since the Junior doesn't have a large memory, it may be easier to use the handheld to get access to your unit.

I have a 25 MB pdf file that has a manual that covers all GE Series one PLC's if that will help. I can email it to you.