Servo motor testing methods

cocoroco89

Member
Join Date
Mar 2016
Location
Kitchener
Posts
13
Greeting everyone,

I have servo motor sitting on the shelf for a long time. It is Allen Bradley MPL series motor. Currently I do not have servo drive to hook it up for test.
Is there any way I can find out if this motor is good or not. Please share your knowledge.

Thank you.
 

Similar Topics

Hi all, New here and new all round to PLC`s. We have a servo drive that runs a cross travel beam backwards and forwards. I am having trouble with...
Replies
3
Views
134
My servo motor instruction is not being executed on the gx works 3 even after the positioning parameters have been set
Replies
0
Views
113
Hi All. I am setting up an Omron 1S Servo Motor to drive a conveyor. It goes forward 200mm, pauses and repeats until it is stopped. However...
Replies
3
Views
690
Hi all, I am having a problem with my servo motor and I'm absolutely stuck as to why it wont run. Without any gearbox or any load attached to...
Replies
9
Views
3,468
We are currently experiencing a fault on 1 of the 3 stepper motors, keying mismatch fault. The stepper motor is SMD23E2-240A-M12S. We bought the...
Replies
8
Views
1,317
Back
Top Bottom