Analog data from FF communication based instruments

nitinkjhankal

Member
N
Join Date
May 2016
Location
Roorkee
Posts
3
Hi all,

I need to collect the analog data like 4-20, mV signal or any digital count from FF based communication instruments for calibration purpose.
please anybody help me how can i read Analog data from that particular instruments.
please reply.
 

Similar Topics

U
SLC500 analog input value data type for EZ Series HMI
I cannot add SLC500 analog input tag (I: 8.3) to EZSeries Touch Panel Editor (V 5.3). I used all the listed tag datatype but it all says "Invalid...
Replies
8
Views
173
Markelov69
M
Z
Retrieving analog input data
I have a strain gauge attached to a load cell. The strain gauge is wired into an analog channel on a ControlLogix 1769 controller at +/-10V. How...
Replies
6
Views
2,424
parky
P
M
High Volume Analog Data Traffic
Wondering if anyone has any suggestions that could help me out. I am looking for recommendations for hardware for an upcoming project. I am...
Replies
3
Views
2,027
GTUnit
G
D
CompactLogix analog input is open, yet data says 20mA+
I am noticing odd behavior with a CompactLogix PLC I have here as a test unit. I have absolutely no I/O wiring on this unit, I just use it to...
Replies
2
Views
2,082
scameron81
S
O
Scaling Data on Flex 1794-IF4I Analog Card
Hello, I have a Flex 1794-IF4I analog input card that I'm needing to read data from a pressure transmitter. I think I may have a scaling issue...
Replies
6
Views
5,013
Ones_Zeros
O
Back
Top Bottom