P_Motor Add-on Instruction - Maintenance Mode

I can't get a newly created motor to latch the output in "Maintenance" mode.


All the other equipment in the application will latch the output and the device will stay in "Starting" mode until you click "Stop.", but a new one that I created today won't. I feel like it is something simple in the setup, but I just can't figure it out.


Control Logix L62
Logix5000 V.20
FTView V. 8.1


Thanks in advance.

are you sure that the code is being scanned/executed? ... did you insert this into a "new" routine - and possibly fail to "call" the routine into operation? ...

Ron Beaufort said:

are you sure that the code is being scanned/executed? ...

Click to expand...

yes, I have verified that it is being called.

Look for something unlatching it in the same scan.