We use DSP-1L (Controlab Inc., in Quebec)phase failure detectors exclusively, but I'd like to find a source of DIN-rail mountable units that take less real estate. I have found lots of 208 & 480V devices, but 600V seem pretty scarce. Can anyone recommend?
Alternative Phase-Failure Relay
- Thread starter rguimond
- Start date
http://www.icmcontrols.com/Threephase-line-voltage-monitor-offering-protection-against-phase-lossreversal-and-unbalance-5060-Hz-190600-VAC-1830-control-VAC-8pin-plug-in-mount-base-sold-separately-Prodview.html
How about something like this? It will mount on a din rail with an 8 pin plug in.
Regards,
How about something like this? It will mount on a din rail with an 8 pin plug in.
Regards,
Similar Topics
Greetings All,
I recently decided to start freelancing in Controls and Automation part time, most of my experience has been with Rockwell...
Recently I have requested a quote from Magnetek for their Impulse Drives but can't raise a response from them.
I've requested a quote FOUR TIMES...
Hello All,
Its been a long time since i've been in the trenches actually doing development. When i was developing I used PicsPro extensively for...
Hello friends,
I'm asking a new question here, after thinking a lot about my problem, I wondered if it wouldn't be easier for me to install new...
Hi all. I'm a uni researcher using FactoryTalk Studios SE (just basic knowledge). Have some previous experience with Factory View32 years ago and...