Allen Bradley 1756 IF8 High speed differential mode

mangan

Member
M
Join Date
Jul 2016
Location
Malmo
Posts
5
Hi!
I have my 1756 IF8 wired in high speed differential mode but i can't configure the RTS smaller than 11 ms. What I understand it should be possible to set as low as 5 ms if module filter setting is 1000 Hz. Is there anything else that i have to do?
 

Similar Topics

R
Allen-Bradley Analogue Input 1756-IF16 Scaling
Hi, I have a ControlLogix system with 1756-IF16 analogue inputs. I can't scale the inputs at the card as there is a requirement to facilitate...
Replies
13
Views
294
robertmee
R
H
A/I module 1756-IF16 Allen Bradley
Hi all, installed on chassis A17 an A/I from Allen-Bradley , problem is what ever I do , all channels are sticked on value 39.9 and cannot change...
Replies
1
Views
143
dummy_bit
dummy_bit
D
Allen Bradley PLC 1756-L81E and EIP module 1756-EN2TR
I am using Allen Bradley PLC 1756-L81E and EIP module 1756-EN2TR for Ethernet/IP communication. My communication works fine but in Get-Attribute...
Replies
2
Views
202
Dsaxena
D
R
Allen Bradley 1756-M02AE axis servo loop error
Dear All: I have the flashing red light on the FDBK indicator. The manual said that it means: The axis servo loop error tolerance has been...
Replies
2
Views
635
robertmee
R
P
Communicate ABB CI 840 IO Master with Allen Bradley 1756 - L75 PLC
Hi Guys, Here I have Started to work on some difficult task I hope I will get some solution here. I wanted to communicate ABB CI 840 IO Master...
Replies
2
Views
899
prakasha
P
Back
Top Bottom