Hey y'all this is my first post. I'm 34, from east TN, and been doing maintenance in factories since my first job after high school. I'm about to start my 7th trimester of night classes in industrial electricity.
The school had mostly basic plc trainers, slc's or micrologix, lights and pushbuttons, one trainer had analog. No steppers or servo control.
I built a home trainer (compactlogix L31, combo IO module, an IO box).
I borrow a laptop with v15 RSLogix 5000 from work.
I have learned so much and now I want to learn motion control. I was looking at using amci 3601 CompactLogix Motion Controller (under $100 from ebay).
It would be nice to use my current hardware but i can always sell it and buy different.
Any recommendations? On a $1000 budget. Thanks
The school had mostly basic plc trainers, slc's or micrologix, lights and pushbuttons, one trainer had analog. No steppers or servo control.
I built a home trainer (compactlogix L31, combo IO module, an IO box).
I borrow a laptop with v15 RSLogix 5000 from work.
I have learned so much and now I want to learn motion control. I was looking at using amci 3601 CompactLogix Motion Controller (under $100 from ebay).
It would be nice to use my current hardware but i can always sell it and buy different.
Any recommendations? On a $1000 budget. Thanks