1771-jmb

Tomatojuce

Member
T
Join Date
Sep 2004
Location
Lancaster, PA
Posts
1
I am attempting to re-build a vision system which uses an Allen Bradley 1771-jmb board connected to a pyramid integrator to trigger the camera. I have been able to trigger the camera by jumping the leads on the 25-pin connector, but am unable to cause the individual relays to communicate. Any input would be great.
 

Similar Topics

5618
Clipped 120VAC waveform output from PLC5 output module 1771-OAD
Preface: Kinda long, so I made section titles Intro: I just want to see if anyone here has seen anything similar. A PLC5-40 series C enhanced...
Replies
3
Views
365
GaryS
G
T
1771-IK AOI and Studio5000 migration
Existing environment shown in attached photo (Existing.jpeg) Proposed Environment shown in attached photo (New.jpeg) I am migrating a PLC5 system...
Replies
0
Views
590
trueninjalo
T
J
DHRIO w/1771 IO Erroneous Adaptor Timeout Error
I have a 1756-L81e v32 using a DHRIO v7.001 in RIO scanner Driving (7) 1771 ASB Modules @ 115k baud. The Racks RPI are set at 48msecs. This system...
Replies
2
Views
900
joseph_e2
J
B
1771 SDN/ C DeviceNet scanner help
Hello, I am setting up for practice and I am having trouble seeing the 1771 Scanner in RsLinx as well as Rsnetworx My setup: slot 0 : PLC-5/40E...
Replies
3
Views
976
BeepBob
B
B
1771 DeviceNet Scanner linear plug
Does anyone know the part number for that plug that plugs into the 1771 devicenet scanner? The manual just says it is a linear plug, its 5 pins.
Replies
3
Views
1,052
bkottaras
B
Back
Top Bottom