Hi!
It was at least 15 years since I done a project with a Siemens S5.
Now I have to make some minor changes (timers etc) on someone else's old program. I know the client uses the DOS version so I'll use their computer. Don't have step 5 software myself.
Problem is that I have forgotten just about everything, so I need to brush up my S5 knowledge. Where do I go, what do I do?
I've done plenty of work in step 7 since but I don't remember what step 5 dos have in common with step 7, if anything.
Any ideas?
It was at least 15 years since I done a project with a Siemens S5.
Now I have to make some minor changes (timers etc) on someone else's old program. I know the client uses the DOS version so I'll use their computer. Don't have step 5 software myself.
Problem is that I have forgotten just about everything, so I need to brush up my S5 knowledge. Where do I go, what do I do?
I've done plenty of work in step 7 since but I don't remember what step 5 dos have in common with step 7, if anything.
Any ideas?