omron zen
- Thread starter gncouch
- Start date
PLCnovice61
Member
seeing as you are trying to write the program, please post it so others can help you get it to operate.
Similar Topics
I am very new so I will try to give as much information as possible. I cannot get a Prolific PL-2303TA USB to RS232 to connect to an Omron ZEN...
Hi, after 30 years involved with automation I'm actually writing my first PLC program and am struggling a fair bit. My background is mechanical...
Hi
I am setting a system up as per the attached picture, 5 inputs that are always present.
These are sensors I have in an injection mould, if...
Hello all, new on here, and relatively new to plc programming.
I am trying to write a program which counts as it receives a cycle end input, and...
Hi there,
wrote my first Omron Zen Smart Relay program yesterday. Had a question about using the internal counter C that I am displaying using...