Controlling Philips Hue via HTTP (CodeSys)

Dossing

Member
Join Date
Jan 2017
Location
Denmark
Posts
2
Hey there

Very new to CodeSys, and an intermediate beginner in PLC's generally.
Im trying to setup a new smart home system, for training purposes mostly.
Using a Raspberry Pi, CodeSys and a Philips Hue system.

So far I, think, I've been able to send a PUT command using the HTTP client.
But with no results. I do get a "xDone" back from the fb, but I think I'm doing something wrong in the convertion "pointer to wstring".
It looks like I'm sending this: "≻湯㨢牴敵}" and not {"on":true}

Been searching for answers for this for a while now, but getting nowhere fast.

Hope some of you can steer my in the right direction with this :)
 
Last edited:

Similar Topics

Compactlogix controller, program has 28 conveyors that use TON's to start the conveyors. The TT sounds a warning horn during start and the DN...
Replies
7
Views
160
I'm a Manufacturing Engineer with limited PLC experience and I am doing some research for our Controls Department. Does anyone have experience...
Replies
4
Views
161
Good Evening , I should know more about Solid State Relays . I have a system with 8) 120 vac Vibrators . These Solid State Relays have...
Replies
24
Views
1,954
Hi All, I am facing one issue with the SEW MDX61B drive. Issue- I want to run a conveyor with this drive in two directions but it runs in...
Replies
0
Views
315
More help again please... See the picture. I want to make the rectangle visible when Mr_Zr_ToggleSwitch is 1, and make it invisible when 0...
Replies
5
Views
2,428
Back
Top Bottom