OMRON CPL1 USB Type2

kalabdel

Member
K
Join Date
Feb 2015
Location
Ontario
Posts
1,108
Hello Gentlemen,


I would connect to an OMRON CPL1 to upload the existing program and want to make sure that the required cable is a simple USB2 to USB Type B. I'm running CXOne 4.4 on Windows 7.

Thanks
Kal

IMG_20170208_170059.jpg
 
Last edited:

Similar Topics

J
Omron CPL1 - transistor - servo control PWM
Hello all, Probably a newbie question, but how to program this (se picture) is it HZ saying something about total time, and duty saying somehing...
Replies
2
Views
1,859
Peter Nachtwey
Peter Nachtwey
M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
1
Views
45
Corsair
C
A
Omron cj1m ETN cpu11 connection with NT631C
Hi dear . I have a system with cj1m cpu11 etn. previously NT 5z HMI was connected with plc. recently my old HMI got damaged. I want to replace it...
Replies
5
Views
77
IO_Rack
IO_Rack
K
Omron AD081-V1 Analog Input Card Calibration (Offset & Gain Adjustment)
Omron AD081-V1 Analog Input Card Offset & Gain Adjustment Entering Adjustment Mode 1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
Replies
0
Views
42
Ko Lin
K
S
Omron NB Screen & NX1P2 PLC Real Number issue
I am working on a project using a NB screen and NX1P2 PLC. I am having a really hard time getting a real number to properly translate through to...
Replies
3
Views
114
drbitboy
drbitboy
Back
Top Bottom