Hi everyone,
After few years off we just tried to run a very old thermoforming machine Cannon-Shelley TP-3624 with a DirectLogic DL-330 D3-330 cpu plc and a Kessler-Ellis ZOIDDC-DCU-L operator panel.
The PLC is working fine, but the battery died in the ZOID and we've lost the software.
Does anyone have a backup of this software, is it possible to restore or rewrite?
Where do we go from here?
I've contacted the manufacturer of the machine and KEP, but both of them said the machine is too old and they have no files on record.
Thanks in advance
Adam
After few years off we just tried to run a very old thermoforming machine Cannon-Shelley TP-3624 with a DirectLogic DL-330 D3-330 cpu plc and a Kessler-Ellis ZOIDDC-DCU-L operator panel.
The PLC is working fine, but the battery died in the ZOID and we've lost the software.
Does anyone have a backup of this software, is it possible to restore or rewrite?
Where do we go from here?
I've contacted the manufacturer of the machine and KEP, but both of them said the machine is too old and they have no files on record.
Thanks in advance
Adam