Hello good morning to All,
I am using Delta PLC AS332P and software is ISPSoft 3.02.
I have a requirement that a PID controller to control the Valve by 4-20 ma by analogue output module.
This valve should be operated by temperature transmitter which value is reading by analogue input module.
I am using function block DPIDE which is available in ISPSoft to monitor PID Control.
Settings are:
PID RUN:ON
SV:20
PV=2000
PIDMODE=1
MOUTAUTO=ON
ScanCycle=10
PID_DIR=ON
PID_EQ=ON
If i am setting MV_MAX=Maximum Output Range=8000
That value i am getting in output value.
I am not getting Clear concept
Can any help me
I am using Delta PLC AS332P and software is ISPSoft 3.02.
I have a requirement that a PID controller to control the Valve by 4-20 ma by analogue output module.
This valve should be operated by temperature transmitter which value is reading by analogue input module.
I am using function block DPIDE which is available in ISPSoft to monitor PID Control.
Settings are:
PID RUN:ON
SV:20
PV=2000
PIDMODE=1
MOUTAUTO=ON
ScanCycle=10
PID_DIR=ON
PID_EQ=ON
If i am setting MV_MAX=Maximum Output Range=8000
That value i am getting in output value.
I am not getting Clear concept
Can any help me