Kinetix 300 with ML 1400
- Thread starter Anisingh
- Start date
http://literature.rockwellautomation.com/idc/groups/literature/documents/qs/cc-qs018_-en-p.pdf
Simple Motion Control via EtherNet/IP with Kinetix 300 Drives Connected Components Building Block
The above manual may help you out.
Regards,
Simple Motion Control via EtherNet/IP with Kinetix 300 Drives Connected Components Building Block
The above manual may help you out.
Regards,
Similar Topics
Hi,
I have to find out which IN/OUT signals is use between the Micrologix and the Kinetix 300.
I have found out that the Kinetix uses EtherNet/IP...
Hi all,
I am developing an application at the minute using a Kinetix 300 and a Micrologix 1400. The servo must follow a shaft on an existing...
Have a system that has been running for over a year and all of a sudden getting a ExcessiveVelocityFault on one of the drives when the MSO command...
Hello PLCS.Net Forum,
First time posting. Let's assume I am a novice.
BASIC PROBLEM:
My servo/linear piston is no longer zeroed to the...
Hello.
I have a few machines that use Kinetix 300 (each machine has two drives). Both drives on one of the machine keep losing IP address. They...