Modicon Concept Literal question

jimdi4

Member
J
Join Date
Aug 2004
Posts
108
Hello,

Programming a MUL_REAL FB in Concept and cannot get literal to be 95%.

I tried .95 and 95% and I still get invalid literal any ideas... :rolleyes:
 
Bingo!

I figured it out after playing around....You have to put a leading zero in front of the literal to get 95%

IE-> 0.95 not .95
 

Similar Topics

D
Modicon Concept 2.6 TOTALIZER block
I hope to use the Modicon Concept TOTALIZER block to totalize a flow rate. I have set up a test in the simulator to familiarize myself with the...
Replies
0
Views
2,115
dmned64
D
J
Modicon Concept Software Recovery
My hard drive crashed on my PC that I was running an old version of Concept. I still have the installation disk but do not have the activation...
Replies
2
Views
1,337
John Marston
J
N
Modicon Concept Display Execution Order
Good day, Is there a way to stop displaying the execution order in the IEC ladder sections of the program. The order started displaying when...
Replies
0
Views
2,049
Nethop
N
L
Modicon Concept 984 Modbus error?
Hi Gents, I am not familiar with Concept (familiar with Modbus however) and I was asked a question from one of my customers about an error they...
Replies
6
Views
2,875
Latzi
L
bluenoser337
Modicon Momentum Concept XXMIT
Pretty new at Concept (AB guy). I have an XXMIT that handles communications with a dozen remote RTUs. I want to monitor the Error and Done bits...
Replies
0
Views
1,715
bluenoser337
bluenoser337
Back
Top Bottom