Moustafa Elsherief
Member
Hello
I use 6GK1415-AA10 to S7-400. I configured the gateway as DP slave successfully and CPU.
configured ASI slaves on simatic as shown in attached file.
Then follow the manual to config the gateway for ASI slaves , using SET/DISPLAY buttons
putting the DP address, after that I expected to see the 2 slaves address ( 1A , 2A) shoown from 3/5 group led.
3 led group is ok but 5 led group is flashing. I assured that ASI slaves is configured with the same address ( 1A , 2A )
my ASI slaves are 2 of 3way valves
I tried to upload the Gateway configuration using step manger but the uploaded configuration is empty
ANY SUGGESTIONS ???
I use 6GK1415-AA10 to S7-400. I configured the gateway as DP slave successfully and CPU.
configured ASI slaves on simatic as shown in attached file.
Then follow the manual to config the gateway for ASI slaves , using SET/DISPLAY buttons
putting the DP address, after that I expected to see the 2 slaves address ( 1A , 2A) shoown from 3/5 group led.
3 led group is ok but 5 led group is flashing. I assured that ASI slaves is configured with the same address ( 1A , 2A )
my ASI slaves are 2 of 3way valves
I tried to upload the Gateway configuration using step manger but the uploaded configuration is empty
ANY SUGGESTIONS ???