calvindodds@hotmail.
Member
Hi All,
I am looking to see if anyone has had this issue before.
I have a TIA portal on site which is programmed in TIA Portal V13.0 but the firmware of the CPU is V4.1.
When I try to upload using TIA portal V13.0 I receive an error when uploading the hardware config.
I cannot add the CPU with Firmware v4.1 only 4.0 which I think is the issue.
I used a TIA portal with V13 SP1 which allowed me to add V4.1 of the firmware but when uploading it stated the program was created in an earlier version of TIA portal.
I am stuck at the moment as I believe the software is written in TIA portal V13.0 but the firmware of the CPU seems to indicated i need SP1 installed.
Has anyone had this problem before.
Thanks in advance
I am looking to see if anyone has had this issue before.
I have a TIA portal on site which is programmed in TIA Portal V13.0 but the firmware of the CPU is V4.1.
When I try to upload using TIA portal V13.0 I receive an error when uploading the hardware config.
I cannot add the CPU with Firmware v4.1 only 4.0 which I think is the issue.
I used a TIA portal with V13 SP1 which allowed me to add V4.1 of the firmware but when uploading it stated the program was created in an earlier version of TIA portal.
I am stuck at the moment as I believe the software is written in TIA portal V13.0 but the firmware of the CPU seems to indicated i need SP1 installed.
Has anyone had this problem before.
Thanks in advance