Conversion PLC5 to ProWorx

sandymax

Member
Join Date
Nov 2004
Location
India
Posts
112
hello all
i am doing one conversion Project
I am stuck with one problem
ihave application in which i have to converts PLC5 prog to Proworx nxt (Quantum 113)
In PLC5 4 Thermocouple cards Configered , now what are the possible
changes required in Proworx Nxt
In PLC5 BTW and BTR instruction are used

thanks
Sandy
 
Quantum thermocouple cards are configured during address assignment using Traffic Cop. The values in the assigned registers are scaled by the card.
 

Similar Topics

Hey everyone, Just used the PLC5/Logix migration utility to convert a program, and while addressing the PCEs, I noticed a lot of errors for "XIC...
Replies
12
Views
1,902
Hey everyone, Just a question regarding the conversion of FAL element addressing between a PLC-5 and Logix5000-series processor. In the...
Replies
3
Views
1,603
I have a box erecting machine that uses a PLC5/20 and SFC currently. I need to convert the equipment to run in its new home which will be...
Replies
0
Views
1,301
I have experience with converting PLC5 to Logix but this system has two PLC5s, one of which is used in adaptor mode. I'm wondering if someone...
Replies
5
Views
2,469
Hello, I am doing a PLC5 to 1756 L81 conversion. I have an issue with what looks like an indexed array bit in the PLC 5 that I am unsure of how...
Replies
1
Views
1,263
Back
Top Bottom