mulderm
Member
Hello,
I want to control a motor by a frequency-inverter using
RSView32 and a PLC5-processor programming by RSLogix5.
I want use RSView32 to create a graphic with 2 button´s
start and stop for starting and stopping the motor
and a display with the speed of the motor and some alarm-text.
Problem is how to configure the tag´s.
On the datasource are 2 options: device and memory.
Device is: receiving data from the plc5 (for getting the speed
of the motor).
But how must I configure the buttom´s start and stop, because
these must sending a signal "1" to the PLC5?
Who can help me?
I am new of RSView32.
Greetings,
mulderm
I want to control a motor by a frequency-inverter using
RSView32 and a PLC5-processor programming by RSLogix5.
I want use RSView32 to create a graphic with 2 button´s
start and stop for starting and stopping the motor
and a display with the speed of the motor and some alarm-text.
Problem is how to configure the tag´s.
On the datasource are 2 options: device and memory.
Device is: receiving data from the plc5 (for getting the speed
of the motor).
But how must I configure the buttom´s start and stop, because
these must sending a signal "1" to the PLC5?
Who can help me?
I am new of RSView32.
Greetings,
mulderm