hi all,
i have an Easyview MT-500 OP which i'm programming with Easybuilder 2.6,
this OP is connected to an SLC5/05 using DF1
i have trouble adressing bits in datafiles higher then 13, how do i adress those, the manual gives me the format fffddd(dd) if i do this nothing hapens, what is the real format i should use??
thanks in advance,
M.
i have an Easyview MT-500 OP which i'm programming with Easybuilder 2.6,
this OP is connected to an SLC5/05 using DF1
i have trouble adressing bits in datafiles higher then 13, how do i adress those, the manual gives me the format fffddd(dd) if i do this nothing hapens, what is the real format i should use??
thanks in advance,
M.