med_amin81
Member
- Join Date
- Mar 2005
- Posts
- 1
i have a broblem with communication between a PLC Alspa C80- 35 and my PC,I use P8 software (Error S37 appear "pas de communication")
Communication with alspa C80 - 35
- Thread starter med_amin81
- Start date
Andrew Evenson
Member
med_amin81,
"pas de communication" means there isnt any communications between your PC running P8 and the PLC. See this thread for a link to Alstoms website where you can find manuals for the PLC and the software.
http://www.plctalk.net/qanda/showthread.php?t=17253
Andrew Evenson
"pas de communication" means there isnt any communications between your PC running P8 and the PLC. See this thread for a link to Alstoms website where you can find manuals for the PLC and the software.
http://www.plctalk.net/qanda/showthread.php?t=17253
Andrew Evenson
Similar Topics
I have created a project in TIA Portal v16 Upd6 with S7-1200 (6ES7214-1AG40-0XB0) and WinCC Unified (PC station). The communication between the...
Hello
We have installed several G.E. Fanuc 90 70 PLC
Everything was ok but suddenly we can not communicate anymore with any PLC with the software...
Apologies for not being the best IDEC programmer. I recently was doing some inspections on a site that had 3 FC6A IDEC processors. The issue is...
Hi all
I need help on this
As in my project used Schneider TM241 controller.
Now I want to communicate Elite energy meter with controller by...
I'm trying to write a data in Arduino using MODWR function block .I used the code I got from online for both PLC and Arduino. I made the wiring...