Can anyone point out a source of information about configuring basic RIO (to an ASB) communication (using RSLogix5). I'm using a PLC 5/30. I have tried using the autoconfiguration. It requires a status file (I used 81...just pulled out of my hat) and then after autoconfig I can find a file N81 listed in the data table. But when with the ASB powered up I have no ASB activity light, and no PLC5 channel B activity light and can't force the outputs on the card I installed in the chassis.
I am basically just hunting/pecking at the setup, because I can't find good instructions about the installation/configuration process. Any hints would be greatly appreciated.
Thanks
I am basically just hunting/pecking at the setup, because I can't find good instructions about the installation/configuration process. Any hints would be greatly appreciated.
Thanks