I have a plc mitsubishi FX0-20MR and I'm using medoc. The problem is that I can't load the program because I don't have rs232 in order for the plc and comuter to communicate. Medoc uses com terminals. Are there other ways to deal with that problem? Do you know a schematic diagram of rs232 so I can try making one.
Rs232
- Thread starter bigjoe
- Start date
Similar Topics
i have an device which can support serial (RS485,RS232),CAN protocol . i want to connect it to an existing MIB 1553B bus ,what device will I need...
Hello:
I have to connect a RS232 Modbus RTU slave that only has Tx, Rx and GND signals to a Modbus RTU master.
However, all RS232 to RS485...
Hi to everybody. I need to read the first 12 characters of the message that a barcode reader sends to the ascii card (1734-rs232 ascii) and I...
I have wasted a week trying to figure out how to connect an SLC5/03 with my laptop.
I do not have and can not Buy the 1747 UIC and PC3 cables.
I...
I'm trying to manually convert a Beijer E200 HMI project onto to a new Mitsubishi GOT gs2107-wtbd. The PLC is a very old A-series AS1CPU and is...