just a question

Unregistered · May 27, 2005

Hi
I just wonder
When i use function "Go to location" with S7-3xx PLCs does she show me if there is an operand in know how protected block?

JesperMP · May 27, 2005

Try to make a know how protected block yourself with a couple of Merker and Timer addresses in it.
Then include the block in a project and fire up the cross reference.

JesperMP · May 27, 2005

When i use function "Go to location" with S7-3xx PLCs does she show me if there is an operand in know how protected block

It is the first time that I have seen STEP7 referred to as being female.
Hmm.. that could explain a few things.

Unregistered · May 27, 2005

poor english

KBrodin · May 27, 2005

JesperMP said:
It is the first time that I have seen STEP7 referred to as being female.
Hmm.. that could explain a few things.

A PLC can't be a "she". It always does EXACTLY what you tell it to do. Which, of course, isn't always what you WANT it to do.

PLucas · May 27, 2005

KBrodin said:
A PLC can't be a "she".

On a flick of a switch it is turned on.....

It doesn't go moody once a month....

Paul

RRobbins · May 29, 2005

I think I will trade my wife in for a new PLC. Must be cheaper to upkeep, too.

The answer to the original question about the "Go to Location" answer in NO. The cross reference function can not examine protected blocks.

Terry Woods · May 30, 2005

I would gladly trade my PLC in for my wife.

She's a lot smarter than I am and my PLCs are only as smart as I program them.

just a question

Unregistered

Guest

JesperMP

Lifetime Supporting Member + Moderator

JesperMP

Lifetime Supporting Member + Moderator

Unregistered

Guest

KBrodin

Member

PLucas

Member

RRobbins

Lifetime Supporting Member

Terry Woods

Member

Similar Topics