I have a project to replace an old ABB Procontic b PLC. I wonder if anybody has experience with this system.
I have the following questions:
1. !E03.01 & S00.00 = T00.00
In the above instruction if input E03.01 AND register S00.00 are 1 then Timer T00.00 begings timing but when will T00.00 go on?
2. !E03.01 & T00.00 = S00.00
The above instruction checks whether T00.00 is on or it turns T00.00 on?
3. If I have output cards with 8 outputs each.Lets say outputs are numbered A03.00 to A3.07. Can I use A03.08 to A03.15 as internal flags? If i use them, when A03.00 is on, A03.08 is also on or they are completely independent?
4. 0100 ! E03.001
0101 & S01.01
0102 =S T00.00
0103 #020E3
In the above instruction if E03.01 AND S01.01 are 1 = sets the duration(20sec) or it also starts the timer?
I have the following questions:
1. !E03.01 & S00.00 = T00.00
In the above instruction if input E03.01 AND register S00.00 are 1 then Timer T00.00 begings timing but when will T00.00 go on?
2. !E03.01 & T00.00 = S00.00
The above instruction checks whether T00.00 is on or it turns T00.00 on?
3. If I have output cards with 8 outputs each.Lets say outputs are numbered A03.00 to A3.07. Can I use A03.08 to A03.15 as internal flags? If i use them, when A03.00 is on, A03.08 is also on or they are completely independent?
4. 0100 ! E03.001
0101 & S01.01
0102 =S T00.00
0103 #020E3
In the above instruction if E03.01 AND S01.01 are 1 = sets the duration(20sec) or it also starts the timer?
