Im having a proble with a error im getting a lot. Its telling me my plc electrospindle cooler check the automatic safety switch, the flow switch of the coolant circuit and the thermal cutout on the pump motor. It is kicking the braker alot. I have checked the AMP. and Volts all is of. Could this be that is getting hot. Please help
plc Electrospindle
- Thread starter twin oaks
- Start date
CaseyK
Member
As much as I would like to go into flyback varistors and capacitor flux, I won't.
Can you give more details, including brand of PLC, model, and CPU module number.
What is your voltage and current on the motor, is it single or three phase, and what is it's horsepower rating.
Are you operating 50 or 60 cycles, or is it through a VFD.
If itis a VFD, do you have an inverter bypass panel on it?
Is it warm, hot, or extremely hot?
What is the current rating on the breaker, and is it a one, two, or three pole.
Do you have a copy of the schematic or plc program that you can list.
Any further information would be of great assistance.
regards.....casey
Can you give more details, including brand of PLC, model, and CPU module number.
What is your voltage and current on the motor, is it single or three phase, and what is it's horsepower rating.
Are you operating 50 or 60 cycles, or is it through a VFD.
If itis a VFD, do you have an inverter bypass panel on it?
Is it warm, hot, or extremely hot?
What is the current rating on the breaker, and is it a one, two, or three pole.
Do you have a copy of the schematic or plc program that you can list.
Any further information would be of great assistance.
regards.....casey
Similar Topics
The past week we received a new piece of equipment from Germany which utilizes siemens controls. Typically in our company we use A.B. controls for...
the conveyor can stop because of a safety sensor or safety switch. And also it can stop because of an object jam detector sensor. If the conveyor...
Good Day to all of you, this is my first post, i will try to explain as best as possible, english is not my natural language. I am performing an...
Hi All,
Someone at work has put a PLC system on my desk, that's just been taken off an idle production line.
He said "It's an S7 PLC. We don't...
I have a project to automate four generator sets. The system will monitor and store the load demand of the factory. Once there's Power outage, the...