I'm new to analog programming and have a problem with my 1769-OF8V output card. This should be straight forward since I am only opening a valve with my 0-10vdc signal using a SCP instruction. The problem I have is I have a constant 5vdc signal at all 6 of the outputs I have enabled on the card but the ladder still shows 0.
INPUT N7:30
MIN 0
MAX 32767
SCL MIN 0
SCL MAX 10
OUTPUT O:5.0
No matter what value is in N7:30 the output remains at 0 and I still have 5vdc at the card.
Settings for each channel are Raw/por, 0-10 and no clamping. It acts like there is a setting wrong, but I don't see anything else.
INPUT N7:30
MIN 0
MAX 32767
SCL MIN 0
SCL MAX 10
OUTPUT O:5.0
No matter what value is in N7:30 the output remains at 0 and I still have 5vdc at the card.
Settings for each channel are Raw/por, 0-10 and no clamping. It acts like there is a setting wrong, but I don't see anything else.