5100 Series Blue Fusion PLC's

zmanvortex

Member
Z
Join Date
Apr 2002
Location
Nebraska
Posts
216
Anyone ever use the 5100 series Blue Fusion PLC's from Control Technology Corporation . We are looking into using them and would like some feedback. I would also like some feedback on the software used to program it. I do software development for both plc's and computers which is why the programming software caught my eye. Thanks
 

Similar Topics

M
Servo 5100 setup software
I'm doing a conversion from a k300 to a k5100 drive and I have question on the scaling with the motion view configuration software for the k300 is...
Replies
0
Views
373
Mgw1970
M
K
Kinetix 5100 Drive Overload
Hi, Again, a topic about Kinetix 5100 servo drives. The controller is L33ER. The servo drive are 2198-E1020-ERS with a TLP-115-200-DJMC2A. There...
Replies
0
Views
539
KonstantinKolev
K
T
Kinetix 5100 Indexing & firing discrete outputs
Hello, I'm in the process of converting a slicer from an Ultra3000 drive to a Kinetix 5100 using the KNX software version 4.00. The current...
Replies
0
Views
524
trschout
T
K
Kinetix 5100 Gantry Synchronized Move
Hi, I have a project where one of the modules is a gantry type structure with 2 servo motor, one from each side of the gantry. The transmission...
Replies
8
Views
1,696
Ken Roach
Ken Roach
L
Micro 850 "E" Implicit Messaging Kinetix 5100
There is a new Micro 850E that allows you to do implicit messaging to a Kinetix 5100 servo and a Powerflex 525. I can't seem to find any...
Replies
6
Views
1,930
thesirowl
T
Back
Top Bottom