Hi guy's,
I need to draw on your wisdom again.
I have a 32 series siemens drive. 6SE3116-8CB40
I can hook up analog input (to Rehostat) and get speed control.
When I try to use PID input. I can't get get drive to respond to this control. I even tried using a current source calibrator to simulate a 4-20 ma input. I also dropped in a 250 ohm resistor to see if it would work with a voltage input. but no success.
These are the paramaters I have set up. other that Motor paramenters. P201-1, P006-0, P023-0, P024-0, P001-007, P010-1, P061-12,P062-13,P210-50, P020-1.
Here is a few pics of the installation.
I need to draw on your wisdom again.
I have a 32 series siemens drive. 6SE3116-8CB40
I can hook up analog input (to Rehostat) and get speed control.
When I try to use PID input. I can't get get drive to respond to this control. I even tried using a current source calibrator to simulate a 4-20 ma input. I also dropped in a 250 ohm resistor to see if it would work with a voltage input. but no success.
These are the paramaters I have set up. other that Motor paramenters. P201-1, P006-0, P023-0, P024-0, P001-007, P010-1, P061-12,P062-13,P210-50, P020-1.
Here is a few pics of the installation.
Last edited:
