defaulting the micrologix1000 to blank {(somewhat the way i am)plus (hacker not cracker) never completely understood))but try to also use my experience in real world troubleshooting ie looking at the led's and determining what external contact is creating the problem))}
i want to delete the password and user program to have a clean platform to build a simulator. the manual (yes i do read them ) indicates you cannot delete the password when set i have also contacted the salesperson who visits. not a clue is there a pinout of the capacitor that resets the chip to accept another user program? the manuals do a good job of explaining the particulars though i do get confused on the instruction press ctrl f1 and cntrl f2 in the sentence to start where was the "or" anyways any thoughts on this would be appreciated using either the phar lap or rslinx whynot upgrade but why be feeble get what the program asks for "hmi" i know its too long what the hell im practicing
i want to delete the password and user program to have a clean platform to build a simulator. the manual (yes i do read them ) indicates you cannot delete the password when set i have also contacted the salesperson who visits. not a clue is there a pinout of the capacitor that resets the chip to accept another user program? the manuals do a good job of explaining the particulars though i do get confused on the instruction press ctrl f1 and cntrl f2 in the sentence to start where was the "or" anyways any thoughts on this would be appreciated using either the phar lap or rslinx whynot upgrade but why be feeble get what the program asks for "hmi" i know its too long what the hell im practicing