halburgepramod
Member
- Join Date
- Jun 2005
- Posts
- 54
can any one pls tell me how to configure analog i/0 cards for mitsubishi plc for fx2n plc with Gx Developer software.
mitsubishi
- Thread starter halburgepramod
- Start date
Hi halburgepramod
You have to use the "TO" and "FROM" instructions.
What kind og analouge card do you have? "AD" or "DA" og both?
The "TO"-Instruction is to configure the card.
The "FROM"- instruction is to read from the card - actual value or any error.
I will se if I can find some manual for you.
Best regards
Dariusch
You have to use the "TO" and "FROM" instructions.
What kind og analouge card do you have? "AD" or "DA" og both?
The "TO"-Instruction is to configure the card.
The "FROM"- instruction is to read from the card - actual value or any error.
I will se if I can find some manual for you.
Best regards
Dariusch
Similar Topics
how to communicate FactoryTalk Optix and Mitsubishi Q Series. I want to know the details of that
HOW to communicate with OPTIX and Mitsubishi's Q Series PLC?? PLEASE HELP ME
I'm at a new job as the sole control engineer and trying to piece together where my predecessor left off. One machine I'm trying to get online...
I'm looking to get some spare keys for this PLC. Does anyone know a source or have a part number? My searches are turning up nothing at the moment.
I'm struggling to get an FR-E800SCE to work on CC-Link IE TSN. I'm sure the issue is with the drive, when I plug in the network cable I get no...