MicroLogix1000

jypower · Dec 26, 2002

Hi I am new in PLC.
Any one tell me connection/cable wiring configuration between MicroLogix 1000 controller to desk top/lab top computer?
If possible could u give me a wiring configuration between 8 pin din plug to 9 pin DB serial plug to COM port.

rsdoran · Dec 26, 2002

Chapter 3
http://www.ab.com/manuals/cp/1761-um003a-en-p.pdf

Ron Beaufort · Dec 26, 2002

pinout for Allen-Bradley 1761-CBL-PM02 cable



this might get tricky since the pins on the MiniDIN 

aren't  numbered - as least as far as MY eyes can see - 

but this should get you going if you're careful - 



this is looking INTO the male pins of the MiniDIN - 

NOT from the solder-side - check the spacing to stay 

oriented and you should be ok - 





          key  

           ^ 

       (5)   ( )  



    (1)    (3) (8)

 

     ( )  (2) (7)

      __________

       flat side





the numbers indicate the terminal numbers on the DB9F - 

the 2 pins that aren't numbered have no connections - 

no guarantee but I think the only three wires you need

are for pins 2, 3, and 5 on the DB9F

edit PS - oops - looks like ron doran beat me to the punch -
that's what i get for trying to be artistic.

MicroLogix1000

jypower

Guest

rsdoran

Lifetime Supporting Member

Ron Beaufort

Lifetime Supporting Member

Similar Topics