macevedo79
Member
hi,
my problem is that when i try to past to "run mode"(green color) the processor mark "faulted"(in red color)and in "goto error" indicated a xx94h(0194) error when this error says
[font=verdana, arial, helvetica]In the REM Run or REM Test mode, a module in slot 1 has been detected as being inserted under power. This can also mean that an I/O module had reset itself (xx=slot number).
but i'm not understanding very well this error, some one tell me in this error [/font]he most likely problem is that your actual I/O hardware does not EXACTLY match the I/O modules that are listed in the "I/O Configuration" window ... to fix this, go to the "I/O Configuration" feature and carefully compare the modules that are listed to the actual hardware that you have installed ... note that you must be "offline" to change this list ... if you have to make any changes to the list, then you will need to "Download" the program to the processor ... you'll find the "Download" selection under the "Comms" menu at the top of your screen ...but
i check the slot number and its all ok then i think maybe, but i extract this module of slot 1 and try whitout this and leave the slot empty, later download my program to Processor and try "run mode" and the same problem but now for slot 2 the same error XX94h (0294)
my problem is that when i try to past to "run mode"(green color) the processor mark "faulted"(in red color)and in "goto error" indicated a xx94h(0194) error when this error says
[font=verdana, arial, helvetica]In the REM Run or REM Test mode, a module in slot 1 has been detected as being inserted under power. This can also mean that an I/O module had reset itself (xx=slot number).
but i'm not understanding very well this error, some one tell me in this error [/font]he most likely problem is that your actual I/O hardware does not EXACTLY match the I/O modules that are listed in the "I/O Configuration" window ... to fix this, go to the "I/O Configuration" feature and carefully compare the modules that are listed to the actual hardware that you have installed ... note that you must be "offline" to change this list ... if you have to make any changes to the list, then you will need to "Download" the program to the processor ... you'll find the "Download" selection under the "Comms" menu at the top of your screen ...but
i check the slot number and its all ok then i think maybe, but i extract this module of slot 1 and try whitout this and leave the slot empty, later download my program to Processor and try "run mode" and the same problem but now for slot 2 the same error XX94h (0294)