WinCC2004 Standard

manmeetvirdi

Member
M
Join Date
Oct 2004
Location
India.
Posts
750
Hi,
I want to pop up the alarm message if the Limit of a tag exceeds certain value.
For this I'am following this route:
Tag Properties-->>Events-->>High Limit-->>ShowAlarmWindow

I have set
Display mode-->> Toggle
Object Name-->> ?????.

My question what to configure in Object Name.

Regards
Manmeet
 

Similar Topics

Mandel314159
Safety Standard For Grippers in Robotics
After some interesting conversation regarding the safety of emergency stops, I saw some posts talking about the safety standard conversation...
2
Replies
21
Views
366
Mandel314159
Mandel314159
C
Programming AB Servo with standard PLC vs PLC w/motion option
I have programmed servos from a handful of variety of manufacturers and series. Each time I used a PLC without motion functions. I have not worked...
Replies
9
Views
724
Peter Nachtwey
Peter Nachtwey
0
A1000 and EPIC David standard speed mismatch
Hello, I'm am engineer for a plastic manufacturer. We swapped out a oem motor with one of equivalent nameplate stats made by marathon on our roll...
Replies
3
Views
483
0nezer0
0
P
Standard servo jitter
I am trying to implement a sfift-by-wire on a vehicle and for that I am using a standard servo motor...
Replies
0
Views
317
pankaj_k
P
P
Panelview Standard RTC and firmware…
Had an interesting experience this morning. An old Panelview 600, 2711-K6C5X series B to be precise, comes up as error 32. Unfortunately it...
Replies
0
Views
207
plvlce
P
Back
Top Bottom