I used a one shot input signal to trigger a shift register,and i am using two counters and two internal relays to trap the error,if it happen to shift more than once per cyle or did not shift at all.is there another neat way to capture these two problems.I have an omron plc. Thank you
shift register trap error
- Thread starter nmk
- Start date
Jay Anthony
Member
How do you tell the difference between a good input signal and a bad input signal?
Similar Topics
I am attempting to reject a bottle If the label fails. The rejection works fine at normal line speed but at low speed the rejector fires (air...
Hi guys,
I am pretty new when it comes to programming. I am working with CX-Programmer and I am having a problem where I have a sensor on my...
Hi all,
i have a very slow indexing machine where we are looking to make everything as bulletproof as possible, money is not much of a factor...
Good morning (EST),
I am trying to implement the code below in on an S7-1200. It's barely half a dozen instructions, but I am stuck; I have not...
Hi everyone
I am completely new to using shift registers and am a bit stuck, my shift register works as should, it is for an overhead conveyor...