PC communication with S5 and PROFIBUS

Zazu

Member
Join Date
Oct 2003
Posts
4
Hello,
I have the next case.
I have a PC with serial ports an i must to communicate with the 4 Simatic S5 PLC by PROFIBUS.For the communication with PROFIBUS i use a RS485/RS232 serial convertor.
My question is what protocol i should to use ? 3964 ? RK512 ?
Any kind of information are veru wellcome.
Thanks in advance
:)
 

Similar Topics

Dear All, I have a KUKA Palletizer machines having Iconics Genesis SCADA installed on its PC. It remained closed for about 7 to 8 years. We are...
Replies
0
Views
944
Good morning, I am looking to establish a communication between one Profibus master and one Profibus slave. I downloaded the Profibus Master...
Replies
58
Views
14,387
We have older Festo electrical servodrives : CMMP-AS-C5-11A-P3 and CMMS-AS-C4-3A with profibus interface cards for control by a Siemens plc. The...
Replies
0
Views
1,242
Hello Everyone! I am looking for a solution for making successful Profibus Communication between ABB 800XA & HOneywell HC90. I had gone through...
Replies
4
Views
2,073
Hello guys, I have problems with the Porfibus communication to my regulator Siemens Sipart DR 21and my PLC rockwell 1756-L161. So, for the...
Replies
8
Views
2,085
Back
Top Bottom