Does anyone of you established a connection between an XBTG (Telemecanique panel) and an S7-300 (Siemens PLC) using the MPI adaptor XBT-Z929 (Telemecanique)?
I did all the setting like described in the adaptors manual, but without success…
The only led on the XBT-Z929 which is on, is the power led!
Do have to do some setting in my PLC too?
Any reply is welcome…
Regards
Leonardo
I did all the setting like described in the adaptors manual, but without success…
The only led on the XBT-Z929 which is on, is the power led!
Do have to do some setting in my PLC too?
Any reply is welcome…
Regards
Leonardo