Ramp requirement in PID Block in AB Controllogix

asim_rana

Member
Join Date
May 2005
Posts
50
Dear experts



We are facing following problem. We are using AB controllogix .PID faceplate which we are providing to client has standard Auto manual features but client also need RAMP requirements which are as under

On selecting RAMP mode operator has to enter following parameters



Set Point Operator will enter desired out level say 50%

Ramp Time In what time control valve will achieve Set Point 50 % in our example



Ramp Interval In how many intervals Contol valve will open 50 %



Operator may enter Ramp time or Ramp Interval .If operator gives Set Point & Ramp time it will acquire desired value with in specific time. Similarly if operator enters Set point & Ramp interval it will acquire desired output in given no of intervals.



I tried to Use RAMP /SOCK function block in RSLOgix 5000 but I am not able to implement it properly. Or any other simpler way to implement this. Any help will be highly appreciated.



Thanks In advance

Muhammad Asim Khan
 

Similar Topics

Dear experts We are facing following problem. We are using AB controllogix .PID faceplate which we are providing to client has standard Auto...
Replies
4
Views
8,698
Hello, I'm quite new with using FactoryTalk View Studio. I am currently using FactoryTalk View Studio 13.00 and creating a runtime file for an...
Replies
4
Views
927
Hello PLCS Nation, I am hoping you can help a newbie find calculations on how to determine Line Ramp Up & Ramp down Speed. We have a machine...
Replies
5
Views
1,162
Hi, i hope somebody here could assist with this problem? we're looking to provide another piece of equipment with steadly increasing voltage from...
Replies
13
Views
2,871
Is it possible to make pulses for a stepper drive with an acceleration/deceleration curve of some sort in ladder. I'm using an Automation Direct...
Replies
9
Views
2,579
Back
Top Bottom