AB 1746-IR8 Lead Resistance Enable Bit

DaveW

Member
D
Join Date
Apr 2005
Location
SoCal
Posts
389
Any know exactly what these configuration bits (14 & 15) are for?
Is it to compensate the lead resistance wires errors automatically?
I read that the update time is slower if they are enabled so just want check if I really need to use them. I'm using P100 3-wire RTD's.
Thanks
DaveW
 

Similar Topics

A
1746-HSCE swap
I had a 1746-HSCE go suspected bad. have to swap the card in the morning. Other than dip switch settings is there any configuration to do?
Replies
1
Views
1,023
Ken Roach
Ken Roach
R
Fault on 1746 L551C
Happy Friday everyone! I recently installed a new module, 1746 NIO4I, into the last slot on this chassis. Got the normal IO mismatch fault, added...
Replies
5
Views
1,569
James Mcquade
J
C
1746-N3 Connector
Does anyone know where to get either new or aftermarket 1746-N3 connectors and cables for SLC 32 point discrete in cards? I have a used MCC that...
Replies
1
Views
1,243
Robb B
R
J
1746-OW16 connection issue using 1747-AENTR
I am looking to replace a SLC5/05 processor with an AENTR adapter. Configured the rack in a compactlogix. The connection to all of the cards in...
Replies
5
Views
2,311
JBooth
J
M
Wiring Banner Q5X into a 1746-NIO4V
Heya guys, I'm looking to connect a Banner Q5XKILAF3000-Q8 (4-20mA) signal into my plc which have a analog input card 1746-NIO4V and was...
Replies
0
Views
1,082
Martindag
M
Back
Top Bottom