Convert WinCC project ( from V5.1 to V6.0) !

nguyentrungkiet

Member
N
Join Date
Sep 2005
Location
ho chi minh
Posts
6
Hi All !
I am a new commer !
I have a WinCC V5.1 project . I have install WinCC V6.0 SP2 and I used "Project Migrator" to convert my project (from V5.1 to V6.0) but It can not finnished (an error about Sysbase 7).
Please guide me how to do that ?

Thanks and best regards !
Kiet !
 

Similar Topics

A
Convert project from siemens protool to wincc scada
Hi all, I have one question about Siemens Protool that I'm using in these days. Is possible to convert a project from protool 6.0 to wincc scada...
Replies
1
Views
3,409
Paul B
Paul B
V
Convert a ProTool project to WinCC
Hello everyone, I have just installed the WinCC flexible 2005 together with SP1 and hotfix so I have never used it before. The project that i...
Replies
6
Views
5,838
JesperMP
JesperMP
E
convert HMI to wincc v6.2(MCP)
Is it possible to convert project wincc flexible 2005 to wincc v6.2
Replies
1
Views
1,220
KalleOlsen
K
aikona
WinCC VBS convert 32 bit Integer to 16 bit
Hi Small problem ,can't find solution .Inside a VBS script I need to extract the low 16 bits out of a 32 bit integer .In PLC lanquage its easy L...
Replies
8
Views
10,326
teo87mat
T
I
Make an HMI convert from inches to PUUs (numeric input) before writing to servo drive
Hello all, I'm currently working on a servo motor linear positioning system (ball screw). I'm all set up regarding communication between my HMI...
Replies
1
Views
115
parky
P
Back
Top Bottom