stevebarker
April 19th, 2006, 07:04 AM
Hi
I have purchased an FX1S PLC to control a simple assembly jig.
I have three sensors to detect that the correct parts have been installed, a start switch, proximity switch and two outputs,a red light for fault and green for ok
I had never done any PLC programming before but I have managed to write a programme that works just using inputs, outputs and timers.
However i have also purchased an FX-10DM-U-E display module.
I would like to use the display for a few simple messages i.e. Start test, Testing, Faulty, OK. etc. but i am having problems working out how to do this.
I would appreciate your help.
Steve
I have purchased an FX1S PLC to control a simple assembly jig.
I have three sensors to detect that the correct parts have been installed, a start switch, proximity switch and two outputs,a red light for fault and green for ok
I had never done any PLC programming before but I have managed to write a programme that works just using inputs, outputs and timers.
However i have also purchased an FX-10DM-U-E display module.
I would like to use the display for a few simple messages i.e. Start test, Testing, Faulty, OK. etc. but i am having problems working out how to do this.
I would appreciate your help.
Steve