Hi!
After som searching on the net I found out that the pc/ppi cable was just a RS232 to RS485 level converter.
And then I found this:
But when I'm trying to communicate with my plc I just get this error:
"Masters exist on the PROFIBUS network and the current device does not support masters.
Try again after selecting a multi-master device."
My plc is a CPU-222
Does anyone know what I may have done wrong?
After som searching on the net I found out that the pc/ppi cable was just a RS232 to RS485 level converter.
And then I found this:
But when I'm trying to communicate with my plc I just get this error:
"Masters exist on the PROFIBUS network and the current device does not support masters.
Try again after selecting a multi-master device."
My plc is a CPU-222
Does anyone know what I may have done wrong?